Assembly Instructions for the Q-2010-RK Rackmount Kit

for Viewsonic VP201b 20.1” TFT LCD monitor

Tools needed:

1. 11/32 socket wrench

2. No. 2 Philip screw driver

3. Tie wrap tool

4. Wire cutter, angle tipped is recommended.

Procedures:

1. Spread the soft foam pad that comes with the packing material on a tabletop.

2. Lay the monitor on the foam pad with the screen facing down. Remove the monitor from its stand by first lifting out the small rear cover and then removing four metric screws from its stand. Store the stand in the original box with its associated hardware. In case of warranty service, you will need to put the monitor back into its original configuration.

3. Then position the Q-2010-RK on the back of the Viewsonic VP201b monitor. Pick the best set of four holes to mount the monitor so that it will appear even between the top and bottom edges. In case you need to drill another hole pattern, use a 3/16” (0.188”) drill and drill a 4-hole pattern at 100 mm or 3.936” centers in line vertically with the existing holes.

4. Insert one set of No. 8 lock washer, No. 8 flat washer, and 4 mm X 16 mm metric screw into each of the four mounting holes. Then securely tighten all four screws.

5. The cable clamps provided are used for tying down the power cable and the SVGA monitor cable. If they are not the right sizes, please use your own or secure the cables with 4” or 5” tie wraps onto the cable clamps.

6. Trim all tie wraps with a wire cutter.

7. Use the black 10-32 screws with No. 10 nylon washers to secure the rackmount assembly onto your rack.

8. If you have any questions or comments, please call Harry Lee, 805-484-2454 or e-mail to hlee@flatmonitors.com.